Super chloroprene adhesive for decoration,synthetic rubber adhesive,
SBS type HN-982
This product is a high strength adhesive that using the imported raw materials and developed by the combination advanced production technology between the west and the east. It has got lots of advantages, such as, excellent performance, easy to construct, environmental-friendly, strong initial viscosity, ultimate strength viscosity, high temperature resistance, aging resistance, easy for brushing. It is able to withstand the erosion of humid, cleanser and grease.
Suitable for the bonding of different materials in different procedure.
Widely used for panel furniture/fireproof board/aluminum-plastic composite board/plastic/wood veneer/plank/plywood board/EVA/PVC/fabric/fiber/floor/rubber etc.
a.Preparation for Operation
- keep the workshop doors and windows open, or switch on the ventilation equipment, ensure good ventilation of the construction site;
- Ensure the bonding material surface is clean without dust, oil, water mark, miscellaneous debris etc。
1,Put proper quantity of adhesive on the materials surface;
2,Brush on both surfaces;
3,Evenly brush the adhesive on the surface with a toothed brush. It should be brushed no more than once to avoid bubbles in the glue layer in the same direction.
c.Drying and pressurizing
- Leave it for 5-15 minutes after brushing, it can be used for bonding when the adhesive layer is dry
- Uniform fully operate, mastering the best position, paste by one time. Gradually bonding from one side to the other.
- Bonding with appropriate pressure, squeeze the air bubble, dense the layer, improve the quality of bonding by using the rubber hammer。
Ensure the construction sites has good ventilation environment. Once open. it can not be exposed to the air for a long time.
- It is necessary to rough if the materials surface is smooth or bonding bad.
- The thickness of the adhesive which gluing on the material are different。 Depending on the material, such as porous material and the rough surface material should be glued more adhesive。
- Leave it for 5-15 minutes after brushing, the drying time might take longer in winter or humidity condition。 In case of humidity weather, the drying time should be adequate to avoid absorbent and paste fast。
- The volume of water in the materials should be lower than 8%。 Otherwise, dry the materials as far as possible when bonding with plywood, flooring, bamboo etc。